IM1 Ex ia I Ma II 1/2G Ex ia IIC T.. Ga II 1/2D Ex ia IIIC T.. Da
IECEx Designation:
I M1 Ex ia I Ma Ex ia IIC T.. Ga Ex ia IIIC T.. Da
EAC Ex Designation:
PO Ex ia I Ma X 0Ex ia IIC T..Ga X 0Ex ia IIIC T..Da X
Certificate:
FTZU 10 ATEX 0062X
IECEx FTZU 16.0015X
RU C-PL.MЮ62.B.04104
Applications
* Measuring range: -50 .. +155°C (temperature class F)
* Stator winding temperature measurement, etc.
* Energy industry
Features
* Connection line 2-, 3-, 4-wire
* Sensor Pt100 according to PN-EN 60751, class B
* Sensor Ni100 according to DIN 43760
* CHIP construction
* Adapted to individual customer requirements
* Llaminated epoxy-resin sheet
* Connection cables in teflon® insulation
Temperature range
Temperature range: -50 .. +155°C (temperature class F)
CHIP (point) construction
CHIP temperature sensors XI-TOPE600 also known as winding stator temperature sensor, is installed in winding slots for temperature measurement and for protection from insulation damage in case of overheating. It is recommended for engine to use six temperature sensors, two for each phase. Temperature sensors should be installed in the hottest spot of winding for the best efficiency results.
Sensing element of CHIP RTD is installed inside laminated epoxy sheet. Cable is connected to the sensor and sealed by epoxy resin. These Stator RTDs are cheaper solution in compare to bifilar construction.
Due to very good dielectrical parameters of HGW and special composition of epoxy resin, these sensors have a high mechanical stability and high voltage resist of 2.5 kV - 5.0 kV as an option.
ATEX versions
Intrinsically safe design is available for applications in hazardous areas. XI-TOPE600 serie is provided with a type-examination certificate for „intrinsically safe“ type of protection according to Directive 2014/34/UE (ATEX) for gases and dust..
Other versions
This data sheet contains only small part of our supplies program of cable resistance thermometers. Upon the customer's request, other versions can also be delivered
